Evo-All with t harness on 2015 Chevy Cruze, automatic with flip key
Programing the bypass module seems easy enough and works just as decribed in the installation guide (used #63371). But when pressing the Door lock 3x the engine will not start, some checks seem to run but thats it. Hitting the lock 3x does the following;
Module pulses a blue light with each lock press. Lock the doors, unlock the doors, dash lights and guages activate then go off, doors then unlock and relock, dash lights and guages come on and go off again and the doors remain locked. The running lights also come on during this seaquence but dont flash. On the bypass module the lights during this sequence go; Red and blue flashing, then red flashing, yellow on, then back to red and blue again, then red and then all out.
I have run through all the troubleshooting guides and nothing seems to apply, the dark blue wire is not grounded, and the parking lights wire is not hooked up. I do have the crimestopper Rf remotes that I plan on using but I have programed those yet as I wanted to get the factory remotes to work first.
(edit) I just hooked my multimeter to the brown/white wire meant for the parking lights and during the start attempt it looks like I'm getting two .6v pulses indicating brake is engaged. Neither foot brake nor hand brake is engaged it the car so I'm not sure what this means?
Any help would be much appreciated.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
